Installing a Brick Paver Walkway or Red Bricks

The use of Bricks or Pavers to develop a pathway or patio matches a house in a way that is unequaled. In addition, setting up a Brick or Paver pathway does not necessarily need a pro.

The key to setting up a Brick or Paver Walkway is to first correctly prepare the location where the bricks/pavers are to be installed. The location must be dug out a minimum of a foot down, eliminating all topsoil and clay soil. In addition, string lines should be strung on each side of the pathway. The string lines indicate the ended up height of the pathway.
As soon as the area has been dug down, 3/4" gravel stone ought to be laid in and tamped down securely. 2" of sand, or stone dust should be spread over the gravel. Again the sand/stone dust ought to be tamped down. Stone dust is preferred. The height between the tamped down sand and the stringline should equate to the density of the brick or paver.

Now that you have a stable base, put a 1" pipeline or journal board the length of the sidewalk on either side of the pathway. Then using a flatedge, e.g. a 2"x4" board, slide it over the 2 lengths of the pipe/ledger board. In doing this you will produce a level surface location to lay the bricks/pavers.

Now place on the level sand/stone dust strips of plastic brick borders. Install a run on both sides of the prepared location. These strips will act as your pathway border and help to preserve the integrity and shape of the pathway.

You can then begin to lay the bricks/pavers when this is done. There are many patterns you can lay. I particularly like the Herring Bone pattern. The secret to laying the bricks/pavers is to make sure that they interlock with each other. Constantly stagger nearby rows of bricks by 1/2 of a brick to interlock them. This will once again assist maintain the stability of the sidewalk.

Inevitably bricks/pavers will require to be cut or split when developing the walkway. Unless you desire to buy or lease a costly wetsaw, I would suggest acquiring an easy brick/paver splitter. It is essentially a sculpt with a wide end that is the width of the bricks/pavers. To actually cut/split the brick/paver, lay it in a bed of sand and location the sculpt at a 75 degree angle over the area where you want to break the brick. Using a hammer strike the butt end of the chisel securely. You may require to do this a number of times. You may also want to turn the brick/paver over and strike the other side of the brick using the hammer and chisle. Within a couple of strikes the brick/paver ought to break cleanly. , if your sidewalk has curves you will need to buy/rent a wetsaw.

.

After setting up the bricks, develop the outside edges with additional sand, and after that shovel in the topsoil and load down securely.
Spread stone dust over the new pathway and sweep into the fractures. Repeat this process a couple of times to make sure the fractures are totally filled. This will complete the interlocking website of the bricks and help to get rid of any weed development. Simply add grass seed to the outdoors edges and you must have a beautiful entryway to your home within a number of weeks.


In addition, setting up a Brick or Paver pathway does not necessarily need a pro. The key to installing a Brick or Paver Walkway is to very first appropriately prepare the area where the bricks/pavers are to be installed. Now that you have a steady base, put a 1" pipe or journal board the length of the sidewalk on either side of the walkway. These strips will act as your sidewalk border and help to keep the integrity and shape of the pathway. Undoubtedly bricks/pavers will need to be cut or get more info divided when developing the sidewalk.

Leave a Reply

Your email address will not be published. Required fields are marked *